Attwood 0169460 Boating Equipment User Manual


 
S3 ELECTRONIC BILGE SWITCH
4801 / 4802
SAVE THESE INSTRUCTIONS
INSTALLATION INSTRUCTIONS 09/01 69460 Rev. B
This electronic bilge switch converts any standard bilge pump to automatic operation. Pump must operate on 12 OR 24 volts D.C. (see chart). The switch can be mounted
separately from the pump; it can also attach to a mounting bracket on all Attwood Tsunami Series Pumps (4606, 4608, and 4612).
!
WARNING:
This product is only intended for use with D.C. voltage systems. A.C.-to-D.C. converted power sources may cause it to function incorrectly.
Connecting the brown wire to ground may cause damage to switch.
Always disconnect the power source when installing or servicing this product.
Always use the fuse amperage rating speci ed for your
pump
model.
IMPORTANT:
Do not allow sealants containing acetic acid – such as silicone rubber – to come in contact with the switch housing. They can damage and crack the plastic, causing the
switch to fail. Sealants with acetic acid smell like vinegar.
If switch sits unpowered for 1 or more years, the 8-10 second power up cycle may run longer than normal for the rst cycle. After that it will return to the proper power up time.
MOUNTING INSTRUCTIONS
Locate electronic switch as close as possible to the bilge pump. If mounting with a Tsunami Series pump, the back slot on the switch may be interlocked with the hook 1.
feature on the pump bracket. Mount switch on the same level or above the inlet of the pump.
With switch in desired mounting position, mark the four mounting holes.2.
Set depth gauge on drill bit to prevent drilling through hull. 3. Drill a 1/8” (3 mm) diameter pilot hole at each mark.
Feed wires out side or rear of switch. Fasten switch using #8 Stainless Steel panhead screws. Be sure screws penetrate wood only; 4. do not screw into the boat hull. (Figure 1)
WIRING INSTRUCTIONS
Wire electronic switch and bilge pump as shown in either of the two diagrams. (Figure 2)
The lead wires (16 Ga.) must terminate in a waterproof connection. Mount wires above the highest possible water mark.
Failure to properly fuse and make the appropriate water-resistant connections will void the product warranty.
FUNCTIONAL INSTRUCTIONS
Once wired properly, switch will run a test cycle 1.
EACH
time supply power is applied. This will cause the pump to run 8-10 seconds.
Switch Delay ON
2. : The switch will turn on once both sensors have 6-8 seconds of constant contact with water. Splashing water will not turn switch on. As long as water
touches both sensors, pump will remain on.
Switch Delay OFF
3. : Once the water level drops below the upper sensor, the off timer will begin. The off timer will run for 60 (+/- 10) seconds and will time out. After 60
seconds the bilge pump will shut off.
To Test the Switch
4. : Hold wet rag across upper and lower sensors (see Figure 3) until the pump turns on (6-8 seconds). Remove rag from sensors. Pump should run for
60 (+/- 10) seconds then shut off.
CARE AND MAINTENANCE INSTRUCTIONS
Periodically inspect switch and clear away debris that has accumulated around the switch housing. Periodically check the electrical connections to ensure that they are water-
proof and mounted high and dry. Periodically clean the stainless steel sensors with a rag.
Figure 1
/ Figura 1
Figur 1 / Abbildung 1
Figure 2
/ Figura 2
Figur 2 / Abbildung 2
Figure 3
/ Figura 3
Figur 3 / Abbildung 3
Figure 3
Vertical Mounting SlotsA.
Upper Sensor B.
Lower SensorC.
Mounting FeetD.
Wet Test RagE.
Figur 3
vertikala monteringsspårA.
övre givare B.
undre givareC.
monteringsfötterD.
våt trasaE.
Figure 3
Fentes de montage verticalA.
Capteur supérieur B.
Capteur inférieurC.
Pieds de montageD.
Chiffon d'essai mouilléE.
Abbildung 3
Senkrechte MontageschlitzeA.
Oberer Sensor B.
Unterer SensorC.
MontagefüßeD.
Nasser TestlappenE.
Figura 3
Ranuras de montaje verticalA.
Sensor superior B.
Sensor inferiorC.
Patas de montajeD.
Trapo húmedo para la pruebaE.
Figure 1
Attwood Tsunami Series PumpA.
S3 Bilge SwitchB.
#8 Stainless Steel Panhead ScrewsC.
Pump BracketD.
Figur 1
Attwood Tsunami-pumpA.
S3-slagströmbrytareB.
rostfria stålskruvar (nr 8) med koniskt huvudC.
pumpfästeD.
Figure 1
Pompe de série Tsunami AttwoodA.
Interrupteur de cale S3B.
Vis n° 8 à tête cylindrique bombée en acier C.
inoxydable
Support de pompeD.
Abbildung 1
Pumpen der Serie Tsunami von AttwoodA.
Bilgenschalter S3B.
Schrauben Nr. 8 aus rostfreiem StahlC.
PumpenhalterungD.
Figura 1
Bomba Attwood serie TsunamiA.
Interruptor S3 para sentinasB.
Tornillos de acero inoxidable de cabeza C.
troncocónica n.º 8.
Soporte de la bombaD.
A
B
© 2009 Attwood Corporation
1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com
C
D
Auto / Manual / Off
Fuse HolderA.
72 (183cm) Max B.
Length From (+) Terminal
To Fuse
3-Position SwitchC.
AutoD.
ManualE.
OffF.
Red (+)G.
Brown (+)H.
Black (-)I.
Neg (-)J.
Pos (+)K.
Battery L.
Auto/manuel/arrêt
Porte-fusibleA.
Longueur maximale de B.
183 cm de la borne (+)
au fusible
Interrupteur à trois C.
positions
AutoD.
ManuelE.
ArrêtF.
Rouge (+)G.
Brun (+)H.
Noir (-)I.
Nég. (-)J.
Pos. (+)K.
BatterieL.
Automático/manual/
apagado
PortafusiblesA.
Longitud máxima de 72 B.
pulg. (183 cm) desde el
terminal (+) al fusible
Interruptor de tres C.
posiciones
AutomáticoD.
ManualE.
ApagadoF.
Rojo (+)G.
Marrón (+)H.
Negro (-)I.
Negativo (-)J.
Positivo (+)K.
Batería L.
auto / manuellt / av
säkringshållareA.
72 tum (183 cm) B.
maxlängd från (+)-pol till
säkring
3-lägesströmbrytareC.
autoD.
manuelltE.
frånF.
röd (+)G.
brun (+)H.
svart (-)I.
neg. (-)J.
pos. (+)K.
batteri L.
Auto / Von Hand / Aus
SicherungshalterA.
183 cm (72 Zoll) B.
maximale Drahtlänge
vom Plus-Anschluss (+)
zur Sicherung
Schalter mit drei C.
Positionen
AutoD.
Von HandE.
AusF.
Rot (+)G.
Braun (+)H.
Schwarz (-)I.
Neg (-)J.
Pos (+)K.
BatterieL.
A
B
C
G
H
I
JK
Auto / Manual
Fuse HolderA.
72 (183cm) Max B.
Length From (+) Terminal
To Fuse
2-Terminal On / Off C.
Switch
Red (+)D.
Brown (+)E.
Black (-)F.
Neg (-)G.
Pos (+)H.
BatteryI.
Auto/manuel
Porte-fusibleA.
Longueur maximale de B.
183 cm de la borne (+)
au fusible
Interrupteur marche/arrêt C.
à deux bornes
Rouge (+)D.
Brun (+)E.
Noir (-)F.
Nég. (-)G.
Pos. (+)H.
Batterie I.
Automático/manual
PortafusiblesA.
Longitud máxima de 72 B.
pulg. (183 cm) desde el
terminal (+) al fusible
Interruptor de encendido/C.
apagado de 2 terminales
Rojo (+)D.
Marrón (+)E.
Negro (-)F.
Negativo (-)G.
Positivo (+)H.
Batería I.
auto/manuellt
säkringshållareA.
72 tum (183 cm) B.
maxlängd från (+)-pol till
säkring
dubbelpolig C.
till/från-strömställare
röd (+)D.
brun (+)E.
svart (-)F.
neg. (-)G.
pos. (+)H.
batteri I.
Auto / Von Hand
SicherungshalterA.
183 cm (72 Zoll) B.
maximale Drahtlänge
vom Plus-Anschluss (+)
zur Sicherung
Ein / Aus-Schalter mit C.
zwei Anschlüssen
Rot (+)D.
Braun (+)E.
Schwarz (-)F.
Neg (-)G.
Pos (+)H.
BatterieI.
Automatic
Fuse HolderA.
72 (183cm) Max B.
Length From (+)
Terminal To Fuse
Wire ConnectorC.
Red (+)D.
Brown (+)E.
Black (-)F.
Neg (-)G.
Pos (+)H.
BatteryI.
Automatique
Porte-fusibleA.
Longueur maximale de B.
183 cm de la borne (+)
au fusible
Connecteur de lC.
Rouge (+)D.
Brun (+)E.
Noir (-)F.
Nég. (-)G.
Pos. (+)H.
Batterie I.
Automático
PortafusiblesA.
Longitud máxima de 72 B.
pulg. (183 cm) desde el
terminal (+) al fusible
Conector para cablesC.
Rojo (+)D.
Marrón (+)E.
Negro (-)F.
Negativo (-)G.
Positivo (+)H.
Batería I.
automatiskt
säkringshållareA.
72 tum (183 cm) B.
maxlängd från (+)-pol till
säkring
kabelkontaktC.
röd (+)D.
brun (+)E.
svart (-)F.
neg. (-)G.
pos. (+)H.
batteriI.
Automatisch
SicherungshalterA.
183 cm (72 Zoll) B.
maximale Drahtlänge
vom Plus-Anschluss (+)
zur Sicherung
DrahtanschlussC.
Rot (+)D.
Braun (+)E.
Schwarz (-)F.
Neg (-)G.
Pos (+)H.
BatterieI.
Input
DC Voltage
Part
Number
Max Allowable
Pump Amp Draw
12 4801 15A 80mA 10mA
24 4802 10A 35mA 7mA
D
E
F
H
I
L
A
B
C
D
E
E
F
F
GH
I
A
B
C
D
E
E
F
F
GH
I
ATTWOOD BILGE SWITCH LIMITED WARRANTY
This Attwood Bilge Switch carries a ve (5) year warranty. See product catalog or www.attwoodmarine.com for details.
Actual Switch
On Amp Draw
Actual Switch
Off Amp Draw
A
B
C
D
E
3 Position Switch
(**May Vary By Brand**)
2 Position (On/Off) Switch
Automatic (No Switch)