Attwood 69303 Marine Lighting User Manual


 
Figure 1
3
®
Light Pole Base
3200 and 3500 Series
Installation Instructions
Attwood marine hardware, navigational lighting, bilge pumps, and other
marine accessories are specified more than any other brand by America’s
best-known boat manufacturers as original equipment. Look to Attwood
for quality replacement parts and marine accessories.
SAVE THESE INSTRUCTIONS
Form Number 69303 Rev. C 03-11
REQUIRED FOR INSTALLATION
Drill with 1/8" (3mm) and 1-1/16" (27mm) bits
Screwdriver
Three #8 stainless steel fasteners (not countersunk)
Deck Gasket for 3200 Base (Attwood #910411) or
non-silicone sealant
LOCATION
If base is used for a red/green bow light, locate in an unobstructed
area as far forward as possible. Center of the base must be aligned
with the centerline of the boat.
INSTALLATION
1.On boat centerline, mark and drill 1-1/16" (27mm) diameter hole.
2.Insert base into hole with hinge toward bow. Align center screw
hole with boat centerline. Mark location of all 3 screw holes.
Remove base.
3.Drill 1/8" (3mm) pilot holes.
© 2003 Attwood Corporation
1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com
4.Bring 12VDC (+) and (-) wires up through deck hole. Connect
wires to base using 1/4" spade connectors.
5.Apply deck gasket or non-silicone sealant to underside of base.
6.Align and fasten base with #8 stainless screws. Do not over tighten.
#8 Stainless
Steel Fasteners
Quasar Light
Pole Base
Deck Gasket or
Non-Silicone Sealant
1/4" Spade
Connectors
Boat Centerline
Bow