Boss Audio Systems MR218OUA Marine Radio User Manual


 
3
INSTALLATION
Notes:
y Choose the mounting location where
the unit will not interfere with the normal
driving function of the driver.
y Before finally installing the unit, connect
the wiring temporarily and make sure it
is all connected up properly and the
unit and the system work properly.
y Use only the parts included with the
unit to ensure proper installation. The
use of unauthorized parts can cause
malfunctions.
y Consult with your nearest dealer if
installation requires the drilling of holes
or other modifications of the vehicle.
y Install the unit where it does not get in
the driver’s way and cannot injure the
passenger if there is a sudden stop, like
an emergency stop.
y If installation angel exceeds 30° from
horizontal, the unit might not give its
optimum performance.
y Avoid installing the unit where it would
be subject to high temperature, such as
from direct sunlight, or from hot air,
from the heater, or where it would be
subject to dust, dirt or excessive
vibration.
TAKE OUT SCREW BEFORE INSTALLATION
Before install the unit, please remove the
two screws.
NOTE: If this unit is installed on the ship,
you can use two pieces of plastic film to
seal the two holes after remove the screws.
And this will be waterproof.
Installation Opening
You can select the installation area and the
size of the opening according to the
installation paper.
Installing the unit
1. Press the OPEN button, then the front
panel will be folded down.
2. First remove the two caps on two sides
of the unit. (Note to pull out the top side
of the cap first.)
Then set the rubber base on the main
unit close to the back of the front panel.
Install the main unit to the dashboard
thought the six screws with washers and
the three brackets. You can use the
plastic film to seal the six holes after
remove the screws on the front panel of
the unit.
30
Take out screw
before installation.