Filter
Top Products
VHF Marine Radio Protocols
Operating Your Radio
29
Nothing Comes Close to a Cobra
®
Advanced Operation
Memory Location Mode
Your radio has unlimited memory locations for storing your
most frequently used channels. These memory locations can
be selected individually or can be scanned. (See page 32
under Memory Location Scan.)
To enter Memory mode, press MEM/ESC button. The display
will show the MEM icon and the Memory Channel bank will
be displayed on the matrix.
To Program Memory Locations:
1. Press and hold the MEM/ESC button for two (2)
seconds. The memory location number will be
displayed on the matrix and the MEM icon will be
turned On.
2. Use the Channel Up/Down button to advance to the
memory location (00-99) you want to program.
3. Press the MEM/ESC button to select the memory
location.
4. Use the Channel Up/Down button to change to the
channel you want to store into the selected memory
location.
5. Press the MEM/ESC button to program that channel.
The memory location will be displayed on the matrix
again.
Repeat steps 2 through 5 to program as many
additional memories as you want.
6. Press and hold the MEM/ESC button for two (2)
seconds. This will return the radio to Memory mode.
7. Press and release the MEM/ESC button again to
return to Marine Standby mode.
VHF Marine Radio Protocols
Operating Your Radio
28
English
Advanced Operation
Using Tri-Watch
Tri-Watch Scan Mode:
1. From Marine Standby mode, press the TRI-WATCH
button. The TW SCAN will display on the matrix
along with the three marine channels stored in the
Tri-Watch memory.
2.
The radio will scan through the three (3) Tri-Watch
memory channels.
3. A signal on any one (1) of the three (3) channels will
stop the scan for 10 seconds to allow you to listen to
the traffic on that location.
NOTE
After the Tri-Watch scan stops to monitor a channel,
as long as you do not press any buttons within 10
seconds, your radio will automatically resume
scanning the Tri-Watch channels.
4. Press the Channel Up/Down button to resume
scanning the Tri-Watch channels or to change the
scan direction.
5. To EXIT the Tri-Watch scan, press the TRI-WATCH
button again. The TRI icon will disappear from the
LCD and the radio will return to Marine Standby
mode.
CAN
H M L
ESC
MEM
ENT SETUP
C
MEM/ESC Button
MEMSAMEATIS VOX
LO MEDHI
VHF
T
R
A
B
GMRS
X
CIU
Memory Location Number
ENT SETUP
CALL
FLOATING MARINE HH350
Channel Up/Down Buttons
MEMSAMEATIS VOX
LOMEDHI
VHF
T
R
A
B
GMRS
X
CIU
Channel Number
TW
EN
TRI-WATCH Button
MEMSAMEATIS VOX
LO MEDHI
VHF
T
R
A
B
GMRS
X
CIU
Tri-Watch Scan Mode
350_VHF_Body_v8_MRHH330_ENG_Body 3/26/13 11:45 AM Page 28