Filter
Top Products
1-5
Mounting the scanner unit
1. Referring to the scanner outline drawing, drill four bolt holes (15 mm dia.) in the radar
mast platform or the deck.
2. Place the corrosion-proof rubber mat (supplied) on the mounting platform.
3. Using the two L-angle metal plates on the scanner top, lift the scanner base with the
antenna radiator and place the scanner unit on the rubber mat. Orient the scanner so
its cable glands face the ship’s stern.
Feeder waveguide
Note 2
L-angle
metal plate
Place the rope around scanner radiator
(feeder waveguide side) to prevent
scanner from rotating when lifting
the scanner base.
Note 1: Take care not to damage scanner exterior
by the rope.
Note 2: Tensile load should not be applied
to scanner radiator.
Note 1
Figure 1-3 How to lift the scanner unit
4. Fix the scanner base to the mounting platform with four M12x60 hex bolts, nuts, wash-
ers and seal washers (supplied).
5. Arrange the grounding terminal at the nearest grounding spot with the M6x25 hex bolt,
nut and washers (supplied). Then, fix a ground wire (RW-4747, 340 mm) to the termi-
nal.
6. Connect the other end of the ground wire to the ground terminal of the scanner unit.
7. Coat grounding terminal and fixing bolts on the scanner unit with silicone sealant (sup-
plied).