Filter
Top Products
2-8
2.3 Monitor
2.3.1 Connection of monitor cable inside processor unit
The monitor cable (a monitor cable comes with FURUNO-supplied monitor) runs between the
RGB Board (inside the processor unit) and the monitor. Route it inside the processor unit as
below. Connect the cable to J2 on the RGB Board. If a converter adaptor is used it may be
necessary to route the cable differently than shown. In any case be sure the cable does not
touch the TX-HV Board.
EXPLODED VIEW
TX-HV Board
(Underneath the plate)
Locking Wire Saddle
45°
Locking Wire
Saddle
Cable inside Locking Wire
Saddle
Cable
Locking Wire Saddle LWS-2H
with M3X10 Pan-head Screw
Figure 2-11 Processor unit, inside view