Filter
Top Products
13
SETTING AND CLEARING THE ALARM
Use alarm mode to turn on the 700 Series at a pre-defi ned time.
When the alarm is activated, your 700 Series will play the last selected input
source at the volume level in use when the unit was turned off.
Menu key Encoder
To set the alarm:
1. Press the Menu key.
2. Turn and then press the Rotary Encoder to select Settings > Clock > Set
alarm.
3. Do one or both of the following:
• Turn the Rotary Encoder to change the hour setting.
• Press the Rotary Encoder to move to the minutes fi eld. Adjust the minutes
setting as required.
• Press the Rotary Encoder to move to the AM/PM fi eld (if enabled). Turn
encoder to select AM or PM.
4. Press the Menu key to save the time settings and exit (the time out feature does
not operate here).
5. Highlight the Alarm enabled checkbox and press the Encoder to enable it ( ).
6. Press any key to exit
To clear the alarm:
1. Press the Menu key.
2. Turn and then press the Rotary Encoder to select Settings > Clock.
3. Highlight the Alarm enabled checkbox and press the Rotary Encoder to disable
it ( ).
4. Press any key to exit
58
APPENDICES
TROUBLESHOOTING
Problem Solution
General
The unit does
not respond to
key presses.
• Reset the unit by pressing the Reset button inside the control panel door.
What is the best
way to prevent
corrosion on
my 700 Series
chrome fi nish?
As with all products with a chrome fi nish exposed to the harsh marine
environment, a little care will help to preserve the fi nish and prevent cor-
rosion. FUSION recommends that you clean any salt water and/or salt
residue from the front panel with a damp cloth soaked in fresh water.
iPod
Why do I get an
error message
when I dock my
iPhone to my
FUSION iPod
inside product?
Some iPhone models may intermittently display the message: “This ac-
cessory is not made to work with the iPhone. Would you like to turn on
airplane mode to reduce audio interference? You will not be able to make
or receive calls.” when initially docked with any FUSION iPhone compat-
ible product. All FUSION iPhone-supported products have been tested
and certifi ed by Apple, and passed Apple’s stringent “Works with iPhone”
self-certifi cation test.
Despite this message, all FUSION iPhone-compatible products are fully
functional and compatible with Apple’s iPhone product line.
Please choose “NO”, or simply wait for this message to time out.
My Head unit
keeps turning
itself off then
back on when
connected to my
iPod
This could be happening due to corrupt fi les and/or a corrupted version of
the operating software on your iPod. If you connect to your computer you
may get a message on the iPod similar to this: “The iPod ‘John’s iPod’ could
not be updated because the fi rmware was corrupt.
Click this link to get a step-by-step guide to solve this issue: http://support.
apple.com/kb/ts1813.”
Reset
Button