GE UPGT650 Marine RADAR User Manual


 
About cycle options. NOTE: Not all features are available on all dryer models.
Lock
You can lock the controls to prevent any
selections from being made. Or you can lock
the controls after you have started a cycle.
Children cannot accidentally start the dryer
by touching pads with this option selected.
To lock the dryer, press and hold the DRY
LEVEL and TEMP buttons at the same time
for 3 seconds. To unlock the dryer, press and
hold the DRY LEVEL and TEMP buttons for
3 seconds.
When the lock function is enabled, CL will
blink in the display with the estimated time
remaining.
My Cycles
To save a favorite cycle, set the desired
settings and hold down the MY CYCLES
button for 3 seconds. A beep will sound
to indicate the cycle has been saved.
To use your custom cycle, press the MY
CYCLES button before drying a load.
To change the saved cycle, set the desired
settings and hold down the MY CYCLES
button for 3 seconds.
See page 8 for more details.
Estimated Time Remaining
Displays the approximate time remaining
until the end of the cycle.
As the cycle begins, you will see an initial
approximate total cycle time in the display.
Then lights will “race” in the display. This
means the dryer is continuously monitoring
the amount of moisture in the load. The lights
will continue until the dryer senses a low level
of moisture in the load. At that point, the
dryer will calculate and display the
approximate time remaining.
10
Consumer Support Troubleshooting Tips
Operating Instructions
Safety Instructions
Installation
Instructions