Filter
Top Products
10. Insert cable connectors into the proper recesses on the cable collector insert. The cable
connectors are keyed to prevent reverse installation, so be careful not to force the connectors into
the wrong slots. If you don’t have a cable for every hole in the insert, install the blank plugs to
protect the control head from the weather.
11. Line up the cable collector insert and cover, with the keying feature, then slide the cover into
place on the insert.
12. Attach the cable collector insert to the cable collector cover using the (2) #6 Phillips screws
provided.
13. Place the control head back onto the mounting bracket. Plug the assembled cable collector into
the back of the control head, pushing gently but steadily until you feel the collector snap into
place. Cable connectors and cable sockets are keyed to prevent reverse installation, so be careful
not to force the connectors into the wrong sockets. Adjust the control head to the desired viewing
angle and secure by tightening the gimbal knobs.
Cable Collector Insert
1
Screws
2
Cable Collector Cover
3
Assembling the Cable Collector
3
1
2
Transducer
Cable Collector Cover
4
5
Cable Collector Insert
6
Inserting the Cables into the Cable Connector Insert
1
2
3 4
Power
Communications
1
2
Temp/Speed
3
5
6
12
531617-1_A - 1197c_ManE.qxp 11/6/2007 4:36 AM Page 12