Filter
Top Products
54
53
Troubleshooting
Before contacting the Humminbird® Customer Resource Center, please read the following
section. Taking the time to review these troubleshooting guidelines may allow you to solve
a performance problem yourself, and therefore avoid sending your unit back for repair.
Matrix™ Doesn’t Power Up
If your Matrix™ Fishing System doesn’t power up, use the Installation Guide that also comes
with it for specific confirmation details, making sure that:
• the power cable is properly connected to the Matrix™ control head,
• the power cable is wired correctly, with red to positive battery terminal and black to
negative terminal or ground
• the fuse is operational
• the battery voltage of the power connector is at least 10 Volts.
Correct any known problems, including removing corrosion from the battery terminals or
wiring, or actually replacing the battery if necessary.
Matrix™ Defaults to Simulator with a Transducer Attached
A connected and functioning transducer will cause the newly-started Matrix™ Fishing
System to go into Normal operating mode automatically. If, when you power up your unit,
it goes into Simulator mode automatically, even though a transducer is already connected,
this means that the control head is not detecting the transducer. Perform the following
troubleshooting tasks:
• Using the Installation Guide that also comes with your Matrix™ Fishing System,
check to make sure that the transducer cable is securely connected to your unit.
Reconnect if necessary, and power up the unit again to see if this fixes the problem.
• Replace the non-functioning transducer with a known good transducer if available
and power up the control head again.
• Check the transducer cable. Replace the transducer if the cable is damaged or
corroded.
Accessories Menu Tab
From any view, press the MENU key twice to access the tabbed Main Menu System, then
press the RIGHT 4-WAY Cursor Control key until the Accessories tab is selected. If no
accessories are attached to the Accessory Bus, no menu choices will appear under the
Accessories tab. If an accessory is attached, however, additional menu choices that support
the accessory will be added automatically. See the Operations Manual that comes with your
accessory for detailed information.
NOTE:
Accessories to enable WeatherSense®, GPS Functionality and the SmartCast® Wireless Sonar Link
require separate purchases. You can visit our website at www.humminbird.com or contact our
Customer Resource Center at 1-800-633-1468 for additional details.
Accessories Menu
(no accessories attached)
Accessories Menu
(with accessories attached)
M47_Man_Eng_531338-1_A.qxd 12/13/2004 12:36 PM Page 58