Mitsubishi HG-SR Outboard Motor User Manual


 
6. HG-MR SERIES/HG-KR SERIES
6 - 10
(3) Permissible loads of servo motor shaft
The permissible radial load in the table is the value measured at the center of the reducer output shaft.
Q: Length of axis (Refer to section 6.8.3, 6.8.4.)
Q/2
Q
Servo motor Reduction ratio
Permissible load (Note)
Permissible radial
load
[N]
Permissible thrust
load
[N]
1/5 150 200
HG-KR053(B)G1 1/12 240 320
1/20 370 450
1/5 150 200
HG-KR13(B)G1 1/12 240 320
1/20 370 450
1/5 330 350
HG-KR23(B)G1 1/12 710 720
1/20 780 780
1/5 330 350
HG-KR43(B)G1 1/12 710 720
1/20 760 760
1/5 430 430
HG-KR73(B)G1 1/12 620 620
1/20 970 960
Note. Do not subject the shaft to load greater than the value.
The value in the table assumes that the load is applied independently.