Filter
Top Products
Re-arming Your MD3095
NOTE: A re-arm kit (MA7203) is required for this procedure.
1) Hold the cover in one hand, reach under the cover with the other
hand and grasp the plastic housing of the inflator. Pull the inflator
toward you, turning the bladder and cover inside out to fully expose
the inflator for re-arming.
2) If the sensor ring is broken, it has been used or damaged (Fig. 10).
Discard the used cylinder/bayonet assembly and replace (MA7203).
3) Check the new cylinder/bayonet assembly to ensure the o-ring is
in place and the sensor ring is intact (Fig. 10). Ensure that the CO
2
cylinder has not been pierced (Fig. 10).
4) Raise, and hold, the lever into the inflator housing.
5) Install a new cylinder/bayonet assembly by engaging bayonet tabs in
housing, pushing in and turning clockwise 1/8 turn to a full stop (Fig.
9).
Tab
Piercing Pin
Cylinder
Lever
Service Indicator
MD3081 and MD3082 Manual Inflator
1/8 Turn
FIGURE 9
6) Examine the service indicator (Fig. 8). Ensure the service indicator
is GREEN. If the service indicator is red, the mechanism has been
fired or is incorrectly fitted and the inflator requires service. See
Re-arming Your MD3095.
NOTE: The service indicator must be green before proceeding.
Compact Tactical Life Preserver Owner’s Manual 6 7 Compact Tactical Life Preserver Owner’s Manual
WARNING: PFD WILL ONLY INFLATE IF CYLINDER IS
TURNED TO A FULL STOP.