Filter
Top Products
104
/ Troubleshooting
Modular ICS Companion Installer Guide P0992639 01
UTAM key
req’d
System disabled Common message for a new
installation, see
Software keys (U.S.
only)
on page 67. The only other time
this alarm should appear is if you are
rebuilding a system:
1. Enter a UTAM Activation Key. See
Software keys (U.S. only)
on page
67.
2. Obtain a Regression Key. See
Obtaining a Regression Key (U.S.
only)
on page 100.
UTAM test
failed
System is disabled.
This alarm appears
only after a restart
- Ensure there is power to the base
stations and RPI or plug-top power
supply
- Ensure that the location and
number of base stations is correct
- Ensure that there are at least four
terminals and base stations
- Ensure that there are sufficient
Radio Credits to support the number
of base stations you have connected
- Restart the system with the correct
system configuration.
-The system may require a UTAM
Recovery Key. See
Obtaining a
Recovery Key
on page 100.
Example
display
Meaning Possible causes and actions