NorthStar Navigation Explorer 721EU Fish Finder User Manual


 
56 Northstar Explorer VHF Series: 721US, 721EU Operation and Installation Manual
13. Two fl at screws for the microphone bulkhead mount
14. Two spring washers for the microphone bulkhead mount
15. Two plain washers for the microphone bulkhead mount
16. Two nuts for the microphone bulkhead mount
17. Two fl ush-mount brackets for recessed installation
18. Two M5x32 screws for recessedinstallation
19. Two M5x10 screws for recessed installation
20. Two plastic stoppers for the recessed installation (not pictured)
21. Installation template (not pictured)
22. One 7 Amp spare fuse (not pictured) in case of accidental reverse of battery polarity
23. Explorer 721 base unit and microphone (not pictured)
24. Explorer 721 protective cover (not pictured)
7-4 Gimbal Installation
1. Hold the mounting gimbal at the chosen location and use a soft pencil to mark the screw hole positions
onto the mounting surface.
2. If you can’t reach behind the mounting surface to attach the nuts, use the self-tapping screws instead
of the fl at screws shown in the picture. If you’re drilling into fi berglass, use a drill bit smaller than 3/16”
(5mm) to drill the pilot holes.
Otherwise, drill the four screw holes where marked, using a 3/16” (5mm) drill bit. Drill completely through
the mounting surface.
3. Use a Philips screwdriver and the set of four fl at screws, spring washers, plain washers, and nuts to attach
the mounting gimbal to the location site.
1
3
4
2
6
5
7
8
9
10
11
12
13
14
15
16
17
18 & 19