Filter
Top Products
18
Northstar NS3300 Pilot
There are four possibilities for auto tacking or gybing:
Tack (SWA is 90° or less) Gybe (SWA is more than 90°)
An error message is displayed if you attempt other tacks or if the tack will end
with the boat in irons.
Note: To view or change the tack mode, tack angle, gybe mode, gybe angle or
tack delay, go to the Options menu (see section 6-3).
Example:
SWA is 120°, so the boat will gybe.
The tack angle is not set to AUTO:
Example:
SWA is 40°. The tack angle is set to AUTO so the boat
changes direction once:
The NS3300 Pilot
counts down the tack
delay.
The NS3300 Pilot
counts down the
tack delay.
To cancel the gybe
at any time, press
End of tack, boat
is at new SWA
End of tack, boat is at new SWA
The course
changes by the
gybe angle
The course changes
again so that the SWA
is the same as the SWA
before the tack
The course
changes so
that the SWA
is the same as
the SWA before
the tack
To cancel the gybe
at any time, press
Wind
If SWA is more than 90° and the gybe angle is set to AUTO
then the boat will change direction once during a gybe, so
that the SWA is the same as the SWA before the gybe.
Press , select Tack/Gybe
then press initiate a tack
to port.
Press
, select Tack/Gybe
then press
initiate a tack
to starboard.
Press , select
Tack/Gybe then
press
to tack
to port.
Press
select
Tack/Gybe then
press
to tack to
starboard.
Press
select
Tack/Gybe then
press
to
gybe to port.
Press select
Tack/Gybe then
press
to gybe
to starboard.