NorthStar Navigation NS3300 Fish Finder User Manual


 
26
Northstar NS3300 Pilot
6 Menus
Many of the NS3300 Pilot features and functions
are operated through menus.
To scroll through menu items, scroll through
items in a list or change data use the Control
Dial. Clockwise scrolls across/down or
increments data.
To select a menu item press
.
To go back to the previous menu press
.
To accept changes press
.
To discard changes press
.
Occasionally items in the NS3300 Pilotmenus
utilize checkboxes.
If the box is ‘checked’ (contains a check or tick),
then that function is selected (enabled) or ON.
6-1 Setup > System
Language
Select the language for the display. The options
are: English, Italian, French, German, Spanish,
Dutch, Swedish, Portuguese, Finnish and Greek.
Backlight
The backlight pop-up is displayed (see also
section 3-4).
The bar setting represents the current level
of backlighting.
Night ModeAllows low contrast Night mode.
Auto – allows night mode to be selected in
backlight pop-up
On – night mode is active all the time
Off – night mode tis not available
Key beep
Enables or disables an audible beep when a key is
pressed or Control Dial is rotated.
Auto power off
Select to have the autopilot power off automatically
every time the boat’s ignition is switched off. This
applies only if the display unit is wired for Auto Power
(see installation manual).
About
Displays information about the unit.
Factory Reset Resets all settings to the factory default
settings. A warning box asks: Are you sure? Select Yes
and press
to confirm, or No or to cancel.
Main control unit – Resets the MCU’s settings
Head unit – Resets just this head unit’s settings
Both – Resets the MCU’s settings and this unit’s settings
If the box is ‘un-checked’ (does not contain a check or
tick), then that function de-selected (disabled) or OFF.
To select or de-select a checkbox, highlight the menu
item using the control dial and press
. The change
will happen immediately.
The main menu for configuring the NS3300 Pilot is the
Setup menu. Press
until the Setup menu is displayed
(normally twice).
The Setup menu and options are summarized in this
chapter. The factory default settings are shown where
applicable. Each Setup menu option is explained in the
following sections.
Tip: In case you
can’t read the current
language, the language
setting is the first item in
the system menu.