Filter
Top Products
Programming Procedures
The FLR Transmitter allows two basic sets of program-
ming procedures: list item selection and entering
numeric values.
List Item Selection Procedure
Note: If you are already in PROGRAM mode and the
selection to be viewed or changed is already
displayed, proceed to step 3 below. If you are in
PROGRAM mode and the selection to be viewed or
changed is not displayed, press the UP or RIGHT
ARROW key and repeat pressing until the desired
selection appears. Proceed to step 3.
1. Press MENU.
PROGRAM appears in the lower left-hand corner and
DISPLAYappears.
2. Press the UP ARROW or RIGHT ARROW key
to move to the desired selection.
3. Press ENTER to view the current selection.
4a. If the current selection is desired, press ENTER
to confirm.
The unit will automatically advance.
4b. If current selection must change, press either
arrow key to scroll through the available choic-
es. Press ENTER to confirm your selection.
The unit will automatically advance.
5. To exit programming, press the MENU button.
The display will change to RUN mode.
Numeric Value Entry Procedure
Note: If you are already in PROGRAM mode and the
desired selection is displayed, proceed to step 3
below. If you are in PROGRAM mode and the desired
selection is not displayed, press the UP or RIGHT
ARROW key and repeat pressing until the desired
selection appears. Proceed to step 3.
1. Press MENU.
PROGRAM appears in the lower left-hand corner and
DISPLAY appears.
2. Press UP or RIGHT ARROW key until the
desired selection displays.
The current numeric value for this selection appears in
the upper section of the display.
3a. If the current displayed value is desired, press
ENTER. The left most programmable number
begins to flash. Press ENTER again to confirm
and keep the current setting.
The unit will automatically advance.
3b. If current selection must change, press ENTER.
The left most programmable number begins to
flash. Use the UP ARROW key to scroll through
the digits 0–9 and change the flashing digit to
the desired value. Use the RIGHT ARROW key
to move the active digit to the right. Continue
using the UP and RIGHT ARROW keys until all
desired digits are selected.
4. Press ENTER to confirm your selection.
The unit will automatically advance.
5. To exit programming mode, press the MENU
key.
The display will change to RUN mode.
FLR Flow Transmitter
Installation & Programming Instructions
Page 8