Omega Engineering FLR9000 series Marine Sanitation System User Manual


 
Programming Flow Chart
The programming flow chart on pages 10 and 11 will
aid understanding of the menu structure of the FLR
Flow Transmitter. It will also help with understanding
the available configuration selections.
Programming Descriptions
Display Mode
The meter can display RATE (flow rate) or TOTAL
(total accumulated flow) or alternate between BOTH
rate and total. Its displayed name is DISPLAY and is
viewed or changed using the List Item Selection
Procedure found on page 8.
Rate Units of Measure
The meter allows the selection of many common rate
units. Its displayed name is RATE UNT and is viewed
or changed using the List Item Selection Procedure
found on page 8.
Rate (Time) Interval
The meter allows selection of several intervals based
on time. Its displayed name is RATE INT and is
viewed or changed using the List Item Selection
Procedure found on page 8.
Total Units of Measure
If the total flow is being displayed, the units for the
total must first be chosen. The monitor allows the
choice of many common totalization units. Its
displayed name is TOTL UNT and is viewed or
changed using the List Item Selection Procedure
found on page 8.
Total Display Multiplier
The meter has the ability to accumulate the flow total
in multiples of ten. For example, if the most desirable
totalization unit is 1,000 gallons, the monitor can easily
be set up for this requirement. Once back in RUN
mode every time the total display increments by one
digit the actual total would be an additional 1,000 gal-
lons. At 1,000 total gallons the total display would read
1, at 3,000 gallons the total display would read 3, etc.
This feature allows the unit to accumulate totals that
would exceed the 8 digit display capacity. Table 2 lists
the available selection choices. Its displayed name is
TOTL EXP and is viewed or changed using the List
Item Selection Procedure found on page 8.
Scale Factor
The scale factor is used to span the meter. Its dis-
played name is SCALE F and is viewed or changed
using the Numeric Value Entry Procedure found on
page 8.
Table 2 - Total Flow Units
E-2
Total display number indicates
increments of 0.01 unit
E-1
Total display number indicates
increments of 0.1 unit
E0
Total display number indicates
increments of 1 unit
E1
Total display number indicates
increments of 10 units
E2
Total display number indicates
increments of 100 units
E3
Total display number indicates
increments of 1,000 units
E4
Total display number indicates
increments of 10,000 units
E5
Total display number indicates
increments of 100,000 units
E6
Total display number indicates
increments of 1,000,000 units
FLR Flow Transmitter
Installation & Programming Instructions
Page 9