Filter
Top Products
3.0 CONFIGURATION
The Model 2035 is simple to install and designed for excellent
reliability. The following instructions will help you set up and install the
converters properly. If you have any questions, please call Patton
Technical Support at (301) 975-1007.
3.1 CONFIGURATION SWITCHES
The Model 2035 uses a set of eight external DIP switches (see
Figure 1, below) that allow configuration to a wide range of
applications. Because all eight switches are in one externally
accessible DIP switch package, there is no need to open the case for
configuration. The configuration switches allow you to select data
rates, parity, word length and flow control selection. The following
section describes all switch locations, positions and functions.
The Model 2035 uses a
miniature
configuration switch package.
To configure your unit, use a small screwdriver and gently push each
switch to its proper setting. The ON and OFF positions are shown in
Figure 2., below. Default settings for the DIP switches are shown in the
table on the following page. Detailed settings follow the table.
2.0 GENERAL INFORMATION
Thank you for your purchase of this Patton Electronics product.
This product has been thoroughly inspected and tested and is
warranted for One Year parts and labor. If any questions or problems
arise during installation or use of this product, please do not hesitate to
contact Patton Electronics Technical Support: (301) 975-1007;
http://www.patton.com; or, support@patton.com.
2.1 FEATURES
• Converts parallel data to serial data and vice versa
• Automatic parallel and serial sensing and selection
• Automatic DCE/DTE sensing and selection
• Serial data rates to 115.2 Kbps
• No AC power required
• Supports both software and hardware flow control
• Ultra-miniature size
• A five-state LED monitors status and diagnostics
• Variety of connectors and cable lengths
• Made in USA
2.2 DESCRIPTION
The Patton Model 2035 Parallel to Serial Converters
automatically convert RS-232C serial data to parallel data format and
vice versa. Incorporating advanced microprocessor technology, the
Model 2035 is able to automatically sense and select parallel and serial
modes, as well as DTE/DCE modes. The Model 2035 requires no AC
power and supports serial data rates to 115.2 Kbps.
For easy configuration, the Model 2035 features a convenient set
of configuration switches. The configuration switches allow the user to
control baud rate, parity, word length and flow control. An easy-to-read
LED indicator displays status and operating condition.
Housed in an ultra-miniature ABS plastic case, the Model 2035
measures only 2.62" x 1.26" x .76". The Patton Model 2035 comes
equipped with a DB-25 female connector on the serial side, and a
Centronics 36 pin male connector on the parallel side. A six foot cable
is built-in. The Model 2035-25M replaces the Centronics 36 pin
connector with a DB-25 male connector.
3 4
Figure 1. The location of the Model 2035 configuration switches
Figure 2. The miniature configuration switch package
OFF
12345678
DHS-8
Configuration
Switch