Filter
Top Products
Page 20 Radar Installation Manual
Port Setup
When an optional Radar Antenna is connected, Port 1 of the NMEA In/Out Communication
Setup menu must be changed to RADAR as shown below for communications.
1. From the Chart page, press [MENU]. Move the ShuttlePoint knob to highlight
SETUP
MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight
ADVANCED SETUP and press [ENT].
3. Move the ShuttlePoint knob to highlight
IN/OUT CONNECTIONS and press [ENT].
4. Move the ShuttlePoint knob to highlight
PORT 1 INPUT and press [ENT].
5. Move the ShuttlePoint knob up/down to select
RADAR and press [ENT].
6. Press [CLR] or move the ShuttlePoint knob to the left until the Chart page is shown.
2.7.4 CPV550 Connections
A switch MUST be connected
to turn the Radar On or Off
Radar
Switch
Battery
Battery Switch
RADAR CABLE
WIRE COL. FUNCTION
BLACK DATA GROUND
ORANGE DATA OUT+
YELLOW DATA OUT-
BROWN DATA IN+
RED DATA IN-
GREEN POWER ON/OFF SWITCH
BLUE POWER ON/OFF SWITCH
BLACK RADAR BATTERY GROUND
WHITE RADAR BATTERY POSITIVE
PLOTTER CABLE
WIRE COLOR FUNCTION
GREEN GND
No connection AUX OUT+
OUTPUT+ (TX+)
BLUE (Port 1) INPUT+ (RX+)
BLACK POWER- /GND
RED POWER+
BROWN(Port1)
Breaker panel
ACC 2
Cable
VIDEO 1
VIDEO 1VIDEO 1GPSGPSAUXAUX
1 RAM 2
1 RAM 21 RAM 2
I/OI/O
VIDEO 2
VIDEO 2VIDEO 2
Figure 2.7.4 - CPV550 Connections