Standard Horizon MDS-8 Marine RADAR User Manual


 
Page 16 Radar Installation Manual
2.7 CHART PLOTTER CONNECTIONS AND SET UP
The following instructions refer to Dome Antennas; refer to Open Array for connections.
2.7.0 CP180 & CP180i Connections
PWR & ACC 1 Cable
A switch MUST be connected
to turn the Radar On or Off
Radar
Switch
Battery
Battery Switch
RADAR CABLE
WIRE COL. FUNCTION
BLACK DATA GROUND
ORANGE DATA OUT+
YELLOW DATA OUT-
BROWN DATA IN+
RED DATA IN-
GREEN POWER ON/OFF SWITCH
BLUE POWER ON/OFF SWITCH
BLACK RADAR BATTERY GROUND
WHITE RADAR BATTERY POSITIVE
PLOTTER CABLE
WIRE C L R FUNCTIONOO
GREEN GND
No connection AUX OUT+
BROWN OUTPUT+ (TX+)
BLUE INPUT+ (RX+)
BLACK POWER- /GND
RED POWER+
(Port1)
(Port 1)
Breaker panel
Figure 2.7.0 - CP180 & CP180i Connections
Port Setup
When an optional Radar Antenna is connected, Port 1 of the NMEA In/Out Communication
Setup menu must be changed to RADAR as shown below for communications.
1. From the Chart page, press [MENU]. Move the ShuttlePoint knob to highlight
SETUP
MENU and press [ENT].