Standard Horizon PS1000 Marine Radio User Manual


 
Phantom PS1000Page 44
Position Request DSC signal.
5. After a DSC position request is transmitted, the trans-
ceiver remains on channel 70 until position data is
received from the polled vessel.
6. When the Phantom PS1000 receives the position
from the polled vessel, RECEIVED POS REPLY” will
appear on the LCD.
7. Press the
[
]
or
[
]
key to see the name and posi-
tion (LAT/LOG) of the vessel polled vessel.
8. If the Phantom PS1000 does not receive a reply,
the LCD will display “NO REPLY.” Press the
[
]
key
and select “SEND” to transmit the call again or “EXIT
to exit the Position Request mode.
NOTE
If the Phantom PS1000 does not receive position data
from the polled vessel, the LCD will show “NO POSITION
DATA
.”
11.8.3 Receiving a Position Request
When a position request call is received from another vessel, a ringing alarm
will sound and POS REQUEST will be show in the LCD. Operation and trans-
ceiver function differs depending on the setting of section “11.8.1 Setting up
Position Reply.”
Automatically reply:
1. When a position request call is received, a calling alarm
sounds 4 times. Then requested position coordinates are
transmitted automatically to the vessel requesting your ves-
sels position.
2. To exit from position request display, press any key.
Manually reply:
1. When a position request call is received from an-
other vessel, “RECEIVED POS REQUEST” will ap-
pear on the LCD and a ringing alarm sounds 4 times.
2. Press the
[
]
key to see the MMSI of the vessel
transmitting the Position Request.