Filter
Top Products
Page 45Phantom PS1000
3 Select type of reply function “SEND” or “NO REPLY”
by using the
[
]
or
[
]
key.
4. When “SEND” is selected, press the
[
CALL
(
SET
)
MENU
]
key. And your position will be
transmitted to the requesting vessel.
5. To exit from position request display, press the
[
16/9
]
key.
11.9 POSITION SEND
The feature is similar to Position Request, however instead of requesting a
position of another vessel this function allows you to send your position to an-
other vessel. Your vessel must have an operating GPS receiver connected for
the Phantom PS1000 to send the position.
11.9.1 Setting up a Position Send Ringer
The PS1000 has the capability to turn off the Position Send ringer.
1. Press and hold down the
[
CALL
(
SET
)
MENU
]
key
until “RADIO SETUP” menu appears.
2. Press the
[
]
key to select “DCS SETUP” menu,
then press the
[
CALL
(
SET
)
MENU
]
key.
3. Press the
[
]
or
[
]
key to select “DSC BEEP” menu,
then press the
[
CALL
(
SET
)
MENU
]
key.
4. Press the
[
]
or
[
]
key to select “POS SEND”
menu, then press the
[
CALL
(
SET
)
MENU
]
key.
5. Press the
[
]
or
[
]
key to select “oF.”
6. Press the
[
CALL
(
SET
)
MENU
]
key to store the se-
lected setting.
7. To exit this menu and return to radio operation mode
press the
[
16/9
]
key.
If you wish to return to enabling the ringer tone, just repeat the above proce-
dure, pressing the
[
]
or
[
]
key to select “on” in step “5” above.
11.9.2 Transmitting a DSC Position Send Call
1. Press the
[
CALL
(
SET
)
MENU
]
key. The DSC Op-
eration menu will appear.
2. Press the
[
]
or
[
]
key to select “POS SEND” menu,
then press the
[
CALL
(
SET
)
MENU
]
key. The trans-
ceiver will beep, and the “Position Send directory”
will appear. (To cancel, press the
[
16/9
]
key)
3. Press the
[
]
or
[
]
key to select the “name” you
want to contact.
4. Press the
[
CALL
(
SET
)
MENU
]
key to send your position
to the selected vessel.