Yamaha 60A Outboard Motor User Manual


 
E
208022
ON
STARTOFF
701026
208016
Procedure
1) Remove the top cowling.
2) Remove the flywheel cover by remov-
ing the bolts.
5-7
3) Prepare the engine for starting. See
“STARTING ENGINE” for procedures.
Be sure the engine is in Neutral and
that the lanyard is attached to the
engine stop switch.
The main switch must be on if the
main switch is equipped on the elec-
tric start model.
NOTE:
Prime start model
If the engine will not start with this proce-
dure, refer to “ENGINE FAILS TO OPER-
ATE”.
4) To start the engine with emergency
starter rope, insert the knotted end of
the rope into the notch in the flywheel
rotor and wind the rope several turns
clockwise. Then, give a strong pull
straight out to crank the engine.
Repeat if necessary.
6H3-9-1L 5 4/26/01 5:34 PM Page 5-7