Yamaha F8A Outboard Motor User Manual


 
4-20
E
EMU00380
CHECKING TIMING BELT
Inspect the timing-belt and replace it if any
to the following signs is observed:
Cracks in the back of the belt or in the
base of belt teeth.
Excessive wear at the roots of cogs.
Rubber portion swollen by oil.
Belt surfaces roughened.
Signs of wear on edges or outer surface
of belt.
Stretching by 10 mm (0.39 in) or more
when the belt is pushed with a finger.
CAUTION:
@
Consult your Yamaha dealer for replacing
the timing-belt.
@
EMU01315
REPLACING FUSE
If the fuse has blown on an Electric start
model, open the fuse box and replace the
fuse with a spare one of proper amperage,
using a fuse puller.
WARNING
@
Be sure to use the specified fuse. An incor-
rect fuse or a piece of wire may allow
excessive current flow. This could cause
electrical system damage and a fire hazard.
@
NOTE:
@
If the new fuse blows again immediately,
consult a Yamaha dealer.
@
1
Fuse box
2
Fuse (10 A)
3
Spare fuse (10 A)
4
Fuse puller
U68T13.book Page 20 Wednesday, August 8, 2001 12:37 PM