Filter
Top Products
Operation
64
2. Push the “” (up) side of the power trim
and tilt switch to tilt the outboard motor up
slightly to the desired position.
WARNING! Using the power trim and
tilt switch on the bottom cowling while
the boat is moving or engine is on
could increase the risk of falling over-
board and could distract the operator,
increasing the risk of collision with an-
other boat or an obstacle.
[EWM01850]
3. To return the outboard motor to the nor-
mal running position, push the “”
(down) side of the power trim and tilt
switch to tilt the outboard motor down
slowly.
EMU41370
Operating in other conditions
Operating in salt water
After operating in saltwater, brackish water, or
water high in other minerals, flush the cooling
system with fresh water to minimize corrosion
and clogging of the cooling water passages
with deposits. Also, rinse the exterior of the
outboard motor with fresh water.
Operating in water containing mud, sand,
silt, debris, or vegetation
Mud, sand, silt, debris, and vegetation in the
water may restrict water flow into the cooling
water inlet covers or clog internal water pas-
sages. Check and clean the cooling water in-
let covers frequently when operating in these
conditions. Flush the engine with clean, fresh
water after use in these environments. Con-
sult your dealer if normal water flow can not
be restored by cleaning the cooling water inlet
covers or flushing with fresh water.
1. Power trim and tilt switch
ZMU07034
N
ZMU06926
N
ZMU06986
1
UP
1. Power trim and tilt switch
ZMU06987
1
DN
U6CB10E0.book Page 64 Wednesday, September 30, 2009 9:49 AM