Filter
Top Products
Maintenance
75
Procedure for changing engine oil using an oil
changer
1. Place the outboard motor in a vertical po-
sition (not tilted). NOTICE: If the out-
board motor is not level, the oil level
indicated on the oil dipstick may not
be accurate.
[ECM01861]
2. Start the engine and warm it up until the
engine speed stabilizes at idle speed.
3. Stop the engine and leave it for 5-10 min-
utes.
4. Remove the top cowling.
5. Remove the oil filler cap.
6. Remove the oil dipstick.
7. Insert the tube of the oil changer into the
oil dipstick guide, and then extract the en-
gine oil completely.
8. Add the correct amount of engine oil
through the filler hole. NOTICE: Overfill-
ing the engine with engine oil could
cause leakage or damage. If the oil lev-
el is above the upper mark, extract en-
gine oil until the oil level is between
the upper and lower marks.
[ECM02270]
1. Oil filler cap
ZMU07021
1
ZMU06951
1. Oil dipstick
1. Oil changer
1
ZMU06917
1
ZMU06950
U6CB10E0.book Page 75 Wednesday, September 30, 2009 9:49 AM