Yamaha VF200 Outboard Motor User Manual


 
Maintenance
79
2. Place a suitable container under the gear
case.
3. Loosen the bolt, and then remove the
cooling water inlet covers on both sides
of the gear case.
4. Remove the gear oil drain screw and gas-
ket.
5. Remove the oil level plug and gasket to
allow the gear oil to drain completely.
NOTICE: Check the used gear oil after
it has been drained. If the gear oil is
milky or contains water or a large
amount of metal particles, the gear
case may be damaged. Have a
Yamaha dealer check and repair the
outboard motor.
[ECM00713]
T
IP:
For disposal of used gear oil, consult your
Yamaha dealer.
6. Remove any metal particles on the mag-
netic gear oil drain screw. NOTICE: If
there is an excessive quantity of metal
particles on the magnetic gear oil
drain screw, this can indicate lower
unit problem. Consult your Yamaha
dealer.
[ECM01900]
7. Place the outboard motor in a vertical po-
sition. Using a flexible or pressurized fill-
ing device, inject the gear oil into the gear
oil drain screw hole.
1. Cooling water inlet cover
2. Bolt
1. Gear oil drain screw
2. Gasket
1
2
ZMU06957
1
2
ZMU06993
1. Oil level plug
2. Gasket
Gear oil quantity:
1.045 L (1.105 US qt, 0.920 Imp.qt)
12
ZMU06994
ZMU06958
U6CB10E0.book Page 79 Wednesday, September 30, 2009 9:49 AM