Filter
Top Products
Trouble Recovery
85
A. Have serviced by a Yamaha dealer.
EMU29433
Temporary action in emergency
EMU29441
Impact damage
WARNING
EWM00870
The outboard motor can be seriously dam-
aged by a collision while operating or
trailering. Damage could make the out-
board motor unsafe to operate.
If the outboard motor hits an object in the wa-
ter, follow the procedure below.
1. Stop the engine immediately.
2. Check the control system and all compo-
nents for damage. Also, check the boat
for damage.
3. Whether damage is found or not, return
to the nearest harbor slowly and careful-
ly.
4. Have a Yamaha dealer check the out-
board motor before operating it again.
EMU40952
Replacing fuse
WARNING
EWM00631
Substituting an incorrect fuse or a piece of
wire could allow excessive current flow.
This could cause electric system damage
and a fire hazard.
If a fuse has blown, replace the fuse accord-
ing to the following procedure.
1. Turn the main switch to the “” (off) po-
sition.
2. Remove the fuse box cover.
3. When replacing the main fuse, remove
the screws, and then remove the main
fuse. Install the spare main fuse, and
then tighten the screws.
ZMU06999
1. Fuse box cover
2. Main fuse (60 A)
3. Fuel feed pump fuse (10 A)
4. Main switch / PTT switch fuse (20 A)
5. Starter relay fuse (30 A)
6. Ignition coil / Fuel injector / Variable cam-
shaft timing / ECM (Electronic Control Mod-
ule) fuse (30 A)
7. Electric throttle valve fuse (10 A)
8. Fuel pump fuse (15 A)
9. Screw
1. Spare main fuse (60 A)
2. Spare fuse (10 A, 15 A, 20 A, 30 A)
3. Fuse puller
9
8
9
1
2345678
ZMU06960
2
1
23
ZMU06961
U6CB10E0.book Page 85 Wednesday, September 30, 2009 9:49 AM