Yamaha VF250 Outboard Motor User Manual


 
Components
29
T
IP:
Adding an in-line 10-micron fuel filter has
been shown to greatly reduce the chance of
fuel contamination problems. Consult your
dealer for information about Yamaha 10-mi-
cron fuel filters if your boat does not have one.
EMU40594
Tilt support shaft (optional)
The tilt support shaft is available as an option
for this outboard motor. The tilt support shaft
is used to secure the outboard motor in the tilt-
ed-up position.
Installing tilt support shaft
1. Fully tilt the outboard motor up.
2. Insert the tilt support shaft between the
swivel bracket and the clamp bracket
from the starboard side of the outboard
motor until the plate on the tilt support
shaft contacts the swivel bracket. Insert
the tilt support shaft so that the end of the
plate is pointing in the direction shown in
the illustration and position the tilt support
shaft in front of the protrusions on the
clamp bracket.
3. Turn the tilt support shaft toward the bow
so that the plate contacts the clamp
bracket.
4. Tilt the outboard motor down slowly until
the swivel bracket contacts the tilt sup-
port shaft, and then check that the tilt sup-
port shaft is secured in place.
Removing tilt support shaft
1. Fully tilt the outboard motor up, and then
remove the tilt support shaft.
1. Fuel filter
1
ZMU06912
1. Tilt support shaft
2. Plate
3. Swivel bracket
4. Protrusion
1. Tilt support shaft
2. Plate
3. Clamp bracket
3
2
4
1
ZMU06970
1
2
3
ZMU06976
U6CB10E0.book Page 29 Wednesday, September 30, 2009 9:49 AM