Yamaha VF250 Outboard Motor User Manual


 
Operation
63
EMU40733
Procedure for tilting down
1. If using the tilt support shaft, fully tilt the
outboard motor up, and then remove the
tilt support shaft.
2. Push the “” (down) side of the power
trim and tilt switch to tilt the outboard mo-
tor down.
EMU28061
Shallow water
EMU40701
Cruising in shallow water
The outboard motor can be tilted up partially
to allow operation in shallow water.
NOTICE
ECM02360
Do not tilt the outboard motor up so that
the cooling water inlet on the lower unit is
above the surface of the water when set-
ting up for and cruising in shallow water.
Otherwise severe damage from overheat-
ing can result.
EMU40711
Procedure for shallow water cruising
1. Move the remote control lever to the neu-
tral position.
1. Trim rod
1. Tilt support shaft
1. Power trim and tilt switch
1
ZMU06924
1
ZMU06925
1
DN
ZMU06941
1. Power trim and tilt switch
1. Cooling water inlet
ZMU06987
1
DN
1
ZMU06942
U6CB10E0.book Page 63 Wednesday, September 30, 2009 9:49 AM