Filter
Top Products
Trouble Recovery
86
4. When replacing a fuse other than the
main fuse, remove the fuse using the
fuse puller. Install a spare fuse of the
proper amperage.
Consult your Yamaha dealer if the new fuse
immediately blows again.
EMU40981
Power trim and tilt unit will not operate
If the outboard motor cannot be tilted up or
down using the power trim and tilt unit be-
cause of a discharged battery or a failure with
the power trim and tilt unit, the outboard motor
can be tilted manually.
1. Stop the engine.
2. Loosen the manual valve screw by turn-
ing it counterclockwise until it stops.
3. Tilt the outboard motor up manually to the
desired position, and then tighten the
manual valve screw by turning it clock-
wise.
EMU41013
Water separator-alert indicator blinks
while cruising
WARNING
EWM02542
Gasoline is highly flammable, and its va-
pors are flammable and explosive.
● Do not perform this procedure on a hot
or running engine. Allow the engine to
cool.
● There will be fuel in the fuel filter. Keep
away from sparks, cigarettes, flames or
other sources of ignition.
● Some fuel will spill during this proce-
dure. Catch the fuel in a rag. Wipe up any
spilled fuel immediately.
● The fuel filter must be reassembled
carefully with the O-ring and filter cup in
place. Improper assembly or replace-
ment could result in a fuel leak, which
could result in a fire or explosion hazard.
If the water separator-alert indicator on the
Command Link tachometer blinks, perform
the following procedure.
1. Stop the engine.
2. Remove the top cowling.
3. Remove the bolts, and then remove the
fuel filter cover.
1. Manual valve screw
1
ZMU06962
1. Water separator-alert indicator
1. Bolt
2. Fuel filter cover
1
1
ZMU06963
2
1
1
ZMU06964
U6CB10E0.book Page 86 Wednesday, September 30, 2009 9:49 AM