Filter
Top Products
3-20
E
UP
DN
UP
DN
702014
403035*
EMU01548
PROCEDURE FOR TILTING UP
Power trim/tilt models
1) If there is a fuel joint or a fuel cock on
the boat, disconnect the fuel line or
close the fuel cock.
2) Push the power trim/tilt switch “UP”
until the outboard has tilted up com-
pletely.
3) Turn the tilt-support lever toward you
and support the engine.
w
After tilting the engine, be sure to sup-
port it with the tilt-support lever.
Otherwise, the engine could fall back
down suddenly if oil in the power
trim/tilt unit should lose pressure.
4) Once the engine is supported with the
tilt-support lever, push the power
trim/tilt switch “DN” (down) to retract
the trim rods.
cC
Be sure to retract the trim rods complete-
ly during mooring. This protects the rods
from marine growths and corrosion
which could damage the power trim/tilt
mechanism.
411043
EMU00303
PROCEDURE FOR TILTING DOWN
Power trim/tilt model
1) Push the power trim/tilt switch “UP”
until the engine is supported by the
tilt rod.
2) Release the tilt-support lever.
3) Push the power trim/tilt switch “DN”
(Down) to lower the engine to the
desired position.
411045
68J-9-12-3 3/26/01 4:16 PM Page 21