Yamaha Z200B Outboard Motor User Manual


 
E
4-27
cC
8 Make sure the main switch (on applica-
ble models) is “OFF” before working on
the battery.
8 Reversal of the battery leads will dam-
age the rectifier.
8 Connect the RED lead first when
installing the battery and disconnect
the RED lead last when removing it.
Otherwise, the electrical system can be
damaged.
8 The electrical contacts of the battery
and cables must be clean and properly
connected, or the battery will not start
the engine.
Connect the RED lead to the POSITIVE (+)
terminal first. Then connect the BLACK
lead to the NEGATIVE (-) terminal.
8 Using a single battery
Connect both red cables 1 and 2 to the
(+) terminal.
w
Do not leave cable 2 unconnected. If it
accidentally contacts the NEGATIVE (-)
terminal of the battery, there will be a
short circuit. Electrical system damage
and a fire could result.
1 Large red lead for starting battery
2 Small red lead for accessory battery charg-
ing (optional part)
3 Large black lead
4 Battery
8 Using an accessory battery
Use a connecting cable between the (-)
terminals of the starting battery and
accessory battery. See the illustrations of
the wiring connections. This cable must
be made from wire equivalent to the start-
ing battery cable 3.
q
w
e
r
901013
68F-9-14-4 2/28/02 12:02 PM Page 28