Open as PDF
QUICK SETUP GUIDE
DX-922 / DX-1022 / DX-1122 / DX-1222
Mobile Battery Pack
Charging your electronic
1 Plug the large end of the USB cable
into the mobile battery’s USB port
2 Plug the small end of USB cable into
The mobile battery automatically
begins charging your device.
Recharge the mobile battery when the
LED starts blinking.
Note: If your device requires a dierent
connector than the one provided, use
the cable that came with your device
• Mobile Battery Pack
• Micro USB Charging Cable
• Quick Setup Guide
Charging the mobile battery
Fully charge your mobile battery pack
before using it for the rst time.
1 Plug the small end of the USB cable
into the mobile battery’s microUSB
2 Plug the large end of the included
USB cable into a standard USB port on
your computer, car charger, or wall
charger (not included). The mobile
battery automatically begins
Before using your new product,
please read these instructions to prevent any damage.
DX-922_DX-1022_DX-1122_DX-1222_14-0686_QSG_V2.ai 1 6/25/2014 2:13:20 PMDX-922_DX-1022_DX-1122_DX-1222_14-0686_QSG_V2.ai 1 6/25/2014 2:13:20 PM