Filter
Top Products
WARNING
Before removing the sensor, be absolutely certain
that the process pressure is reduced to 0 psig and
the process temperature is lowered to a safe level!
Model 404
ENDURANCE
™
Conductivity Sensor
Instruction Sheet
PN 51A-404/rev.M
December 2010
If the sensor is installed in a sidestream
with the sample draining to open atmos-
phere, bubbles may accumulate on the
electrodes. Trapped bubbles will cause
errors. Normally, as bubbles accumu-
late the conductivity reading drifts down.
To control bubble formation, apply a small
amount of back pressure to the sensor.
SENSOR SPECIFICATIONS
SPECIFICATIONS
MODEL 404-16 (PVC body) MODEL 404-17 (stainless steel body)
Wetted Materials Titanium, PEEK (glass filled), PVC, Titanium, PEEK (glass filled),
EPDM, polyethylene 303 SST, EPDM
Temperature Range 32-140°F (0-60°C) 32-212°F (0-100°C)
Maximum Pressure 20 psig (239 kPa abs) at 60°C (140°F) 100 psig (791 kPa abs)
100 psig (791 kPa abs) at 25°C (77°F)
(use FNPT fittings only)
FIGURE 1. Installation of Model 404 Sensor
For additional information, please visit our website
at www.emersonprocess.com/raihome/liquid/.
INSTALLATION
The wetted sensor materials may not be compatible
with process com position and operating conditions.
Application compat ibility is entirely the
responsi-
bility of the user.
CAUTION
SENSOR/PROCESS
APPLICATION COMPATIBILITY
WARNING