Fujitsu FTP-622DSL001/011/012 Printer Accessories User Manual


 
24V DRIVE INTERFACE BOARD (PARALLEL)
FTP-622DCL001/011/ FTP-622DSL001/011/012
1. Centronics
(1) Connector (CN1)
Connector part number : FCN-605Q030-G/S (Fujitsu Components)
Mating connector part number : FCN-607B030-G/D (Fujitsu Components) or equivalent
No. Signal I/O Contents No. Signal I/O Contents
1 PRSTB I Data strobe 2 PRSTB-RET
Connected to logic GND
3 PRDT0 I Data 0 4 PRDT0-RET
Connected to logic GND
5 PRDT1 I Data 1 6 PRDT1-RET
Connected to logic GND
7 PRDT2 I Data 2 8 PRDT2-RET
Connected to logic GND
9 PRDT3 I Data 3 10 PRDT3-RET
Connected to logic GND
11 PRDT4 I Data 4 12 PRDT4-RET
Connected to logic GND
13 PRDT5 I Data 5 14 PRDT5-RET
Connected to logic GND
15 PRDT6 I Data 6 16 PRDT6-RET
Connected to logic GND
17 PRDT7 I Data 7 18 PRDT7-RET
Connected to logic GND
19 ACKNLG O Data input acknowledge 20 ACKNLG-RET
Connected to logic GND
21 BUSY O Busy 22 BUSY-RET
Connected to logic GND
23 RINF2 O Printer status 24 INPRM-RET
Connected to logic GND
25 SLCTIN I Printer select 26 INPRM I Reset
27 RINF1 O Printer status 28 RINF3 O Printer status
29 ATF I Paper feed request 30 GND Logic GND
(2) Connector pin assignment
Notes:
• Symbol “——” means a negative logic signal.
• “–RET” signal is a return signal of the twisted pair cable.
• “I” or “O” means a signal direction from the interface board side.
INTERFACE
(3) Connector pin number
FCN-605Q030-G/S (Fujitsu Components) or
equivalent
(4) Data input signal timing
No.1
No.2
No.30
PRDT0~7
PRSTB
BUSY
ACKNLG
t1 t3
t2
t4
t5
:t10.5 µsec
:t20.5 µsec
:t30.5 µsec
PRSTB to BUSY= “H”
ACKNLG pulse
:t40.5 µsec
:t5=5.0 µsec
.
.
Data set time
PRSTB pulse
Data hold time
FOR FTP-622/632/642MCL001/002/301/302/303/304
1