Filter
Top Products
Assembly Instructions
I. Frame and Vinyl Trampoline
Assembly Instructions
(See page 8 for mesh trampoline instructions.)
Note ~':
All directions referring to "right," "left,"
"front" and "back" are based on looking from
the stern toward the bow.
1. First, with the trampoline track facing
forward, slip the rear crossbar (part no. 1)
onto the right hull (part no. 2). The factory-
installed support castings slide into the
crossbar. Be sure the crossbar fits entirely Fig. 2
over the support casting. It may be neces-
sary to tap the crossbar onto the hull with
the rubber mallet. See Figure 1.
Fig. 3
eyestrap is attached to its crossbar and
positioned as shown in Figure 3, tighten the
Fig. 1 eyestrap.
2. Slide one of the four eyestraps (part no. 3) 6. Attach the front crossbar (part no. 5) onto
on the crossbar by slipping the square nut the left hull (part no. 6) over the crossbar
inside the track. The eyestrap should be receiver casting. Slide the eyes trap on as in
positioned as close to the hull as possible, step 5.
without touching it. 7. Slide the left corner of the trampoline into
the right side of the front crossbar from
Note right to left. The flap on the trampoline
should be on the top on this side. Now slide
The trampoline (part no. 4) is split diagonally on the last eyestrap (part no. 3).
into two halves. The right, rear section of the 8. Now slide the small bolt rope down the
vinyl trampoline has Velcro@ patches sewn to siderail of the left hull. Check to make sure
it. The left, forward section has a 4-inch flap there is an eyestrap on all four corners of
also with Velcro@ patches. the trampoline.
9. You can now join the left hull, the forward
3. Now, insert the rear bolt rope of the vinyl crossbar, and the trampoline assembly to
trampoline (item 5) into the crossbar track the right hull rear crossbar and trampoline.
and slide it across from left to right. First, attach the left side of the rear cross-
4. Now slide the right trampoline bolt rope bar and the left hull, making sure the
through the track on the right hull. Refer to crossbar is completely over the support
Figure 2 for completed procedure. casting. Next, slip the front, right receiver
5. Slide the second eyestrap (part no. 3) onto into the right side of the front crossbar so
the crossbar so one eyestrap is on each side each corner of each crossbar fits snugly
of the trampoline on the crossbar. As each over the castings as shown in Figure 1.
-5-