ACR Electronics Y1-03-0165 Marine Lighting User Manual


 
9
Y1-03-0165 Rev. D
3.9 Stroboscopic Flashing Light
The SM-2 Flashing Light uses a capacitor discharge xenon flashtube and meets the following requirements:
A. A completely sealed solid state circuit converts power from the battery and supplies it to the flashtube.
B. A suitable capacitor discharge xenon flashtube is provided which is compatible with the electronic flashing circuit
and lens to provide the required light output. The service life of this flashtube is rated for over 1,000,000 flashes.
C. The light will flash at a rate of 60 ± 1 flashes per minute with a minimum intensity of 2 cd for a minimum of 15
hours. Light from each flash is radiated in all directions of upper hemisphere.
3.10 Battery Connection
All operating voltages are furnished by an integral battery pack. Operating voltage is 6.0 VDC. (Shipped without battery
from factory)
Electrical connections between the main circuit board and the associated battery are accomplished by the use of clearly
marked terminals and color-coded lead wires.
3.11 Buoyancy
The SM-2 is independently buoyant.
A matter of balance
Marker lights need to float upright for maximum visibility. The 6 volt lantern batteries provide the ballast for these
lights. Although these batteries are the same size, their different chemistries cause them to have varying
weights. It is imperative that only the 6 volt battery models suggested are used. Too little ballast and the light
will lie over on its side and be ineffective; too much weight and the light could sink. If you have any doubts that
you are using a battery of appropriate weight, test the light by placing it into shallow water. The results will be
obvious; if the light floats upright, it's good. If the light sinks, the battery is too heavy.
3.12 Technical Data
Pertinent technical data is listed below:
ITEM
CHARACTERISTICS
Dimensions
13.65" (34.67 cm) length
4" (10.16 cm) diameter
Weight
3 lbs, 4 oz. (1.474 Kg), including battery
1 lb, 13 oz. (.822 Kg), excluding battery
Modules (1)
Completely sealed electronics
Flashing Rate
60 times per minute ± 1
Flashing Light Intensity
Minimum of 2 candelas per flash in all directions of upper hemisphere
Power Requirement
Standard 6.0 volt lantern battery with screw terminals
Material
Plastic blend case, lexan lens
Activation
Automatic gravity switch
Bracket
Plastic blend mounting bracket
Recommended Battery Replacement Interval
1 Year
Max battery weight
1.49 lbs (675 grams)