Advanced Elements AE1062 Boat User Manual


 
2 Set Up and Inflation
2.1 Set Up
1. Pull your SUP out of its bag and un-fold it.
2. Locate the Fin holders on the bottom side of the board at the tail end. Take each Fin and hook them into place
making sure that the longer portion is going towards the end of the board. You will need to bring the two Fin
holders close together in order to get each Fin hooked into place. See images 1 and 2.
a. NOTE: For the Fishbone SUP, you will notice that the center fin is larger and the fin mount is different.
Start by sliding the front hook of the Fin into place on the Fin mount and then slide the Deep Fin into
place and seat it the rest of the way into the Fin mount. Once the Deep Fin is in place, secure it using the
locking pin that is tethered to the Deep Fin. See image 3. At this point, pull up on the fin to make sure
you have it locked in position. See Image 3.
3. Once the Fins are in place, turn the board over so that the valve at the front of the board is facing up.
Image 1 Image 2
Image 3
2.2 Inflation
Pump Set-up:
Your Single Action Hand Pump comes with a removable pressure gauge that needs to be attached to the pump before
use. Note: When the pump is stored, it is recommended that you detach the pump gauge and store it somewhere that
the gauge will be protected from being crushed or damaged.