Filter
Top Products
LED Mushroom User Manual 7 Rev. 4
Hanging Clamp
Note!
Clamp is sold separately.
Mounting
Orientation
This product may be mounted in any safe position as long as there is adequate room for ventilation.
Rigging
It is important never to obstruct the fan or vents pathway. Mount the
product using, a suitable “C” or “O” type clamp. Adjust the angle of
the fixture by loosening both knobs and tilting the fixture. After finding the
desired position, retighten both knobs.
· When selecting installation location, take into consideration lamp
replacement access and routine maintenance.
· Safety cables must always be used.
· Never mount in places where the fixture will be exposed to rain, high
humidity, extreme temperature changes or restricted ventilation.
· Do not mount more than 3 fixtures with the X-bracket.
4. OPERATING INSTRUCTIONS
Standalone Mode (Sound-Active, Auto Mode):
This mode allows a single unit to run to the beat of the music.
1) Set dipswitches position to Sound Active or Auto Mode.
Mode Dipswitches
Sound Active 1-10= Off
2) The unit will react to the low frequencies of music via the internal microphone in Sound Active
mode
3) Use the audio sensitivity knob on the back of the unit to make the unit more or less sensitive in
Sound-Active mode. Turning the knob counterclockwise decreases the sensitivity; turning the
knob clockwise increases the sensitivity.
DMX Mode
This mode allows the unit to be controlled by any universal DMX controller. If you are unfamiliar with
DMX, please read the DMX Primer on page 13.
1) Set dipswitches position to DMX mode.
Mode Dipswitches
DMX 10= On
2) Use dipswitches 1-9 to set the DMX address.
DMX Channel Values
CHANNEL
VALUE
FUNCTION
1
000 ó 014
015 ó 100
101 ó 255
Control/Operating Mode
No function
LED’s on
Auto
2
001 ó 085
086 ó 170
171 ó 255
Motor Rotation
Counter-clockwise motor rotation (Slow ~ Fast)
Clockwise motor rotation (Slow ~ Fast)
Motor rotation right-to-left-to-right (Slow ~ Fast)
-Note: Channel 1 will override the motor control channel (channel 2)