Filter
Top Products
!
11
NOTE: Fuses and Wires
Regulations may require that the Model 833 be
fused.If installing a fuse, use a 10A fuse wired with
1.5mm or equivalent wire.The voltage drop across the fuse,
its holder, and connectors must be less than 1% of the
nominal system voltage.
Discharge Adjustments
Ta ble 3 lists the voltages per cell under load that correspond
to an empty indication on the gauge (lockout point).
Table 3. Discharge Adjustment Settings
Setting Volt/Cell at Empty
K 1.57
L 1.63
M 1.68
N 1.73 (factory setting)
O 1.78
P 1.82
Q 1.84
R 1.86
S 1.89
T 1.91
U 1.93