Dell 3000CN Marine Radio User Manual


  Open as PDF
of 2
 
Slide the width guides to the edge of the tray. The width
guides should be fully extended. Squeeze the length
guide and slide it to the edge of the tray.
Load the paper in the tray, making sure the paper does
not go above the maximum fill line. Slide the width and
length guides against the edge of the paper.
Insert the tray.
On the operator panel, press the up/down arrow buttons,
if necessary, to change the size and type of paper loaded
in your printer. When you find the correct size/type,
press .
When you do not use the optional tray with the Dell Laser
Printer 3000cn, load the paper in the multipurpose feeder.
Before printing a document, make sure the paper
extender is fully extended.
Connect your printer to a computer or network. Click Cancel on any New Hardware screens if they
appear.
16
When using a USB cable When using an Ethernet cable When using a parallel cable
17
18 19 20 21 22
Managing Your Printer From the Web |
Managing your printer from the web is only available if your printer is connected to a network.
Network printing is even easier with the
Dell PPrinter CConfiguration WWebTool
.
After proper configuration, the
E-MMail AAlert SSetup
feature emails you when toner and paper supplies are running low, or when
the printer needs attention. The
Copy PPrinter SSettings
feature lets you quickly and easily copy your 3100cn printer’s settings to
another printer. To launch the
Dell PPrinter CConfigu
ration WWeb TTool,
type your network printer IP address in your Web browser. If
you don’t know your printer IP address, print a Printer Settings page.
For more information on managing your printer from the web, see your
User’s Guide.
If the IP address shows 0.0.0.0 under the TCP/IP heading, you need to assign an address to the printer.
See your
Owner’s Manual
for instructions.
Printed in China /
www.dell.com/supplies
Insert your
Drivers and Utilities CD
.
Run the Dell installation software. See your
Owner’s Manual
for net-
work installation instructions.
When the New Hardware Wizard screens appear, click
Next
on all
screens. Then click Finish on the last screen.
Complete the Dell installation software setup. When the
Congratulations!
screen appears, click
Print TTest PPage
to print a test
page or click
Finish
to exit.
If you purchased any of the following options, refer to the
User’s Guide
for installation instructions.
• Optional tray (250-sheet tray module or 500-sheet tray module)
• Duplex module
• Multi protocol card (for the 3100cn only)
Screen image example from the 3100cn
23
With the lever in the upright position, hold the drum cartridge by the handle, align the arrows on the drum cartridge with the
corresponding arrows on the printer and guide the cartridge in until it snaps into place. Pull down the lever on the right to lock
the drum cartridge in place. Close the top cover and then the front door.
15
NOTICE: After installing the drum cartridge, the printer makes an adjust-
ment for about one to two minutes. Do not turn off the printer during this
time.
24 25 26 27
T6131A00
 previous