Emerson LARGE AC ELECTRIC MOTORS Outboard Motor User Manual


 
U.S. ELECTRICAL MOTORS
INSTALLATION AND MAINTENANCE
FIGURE 1B
Typical Construction With Four Lifting Lugs
FIGURE 1A
Typical Construction With Two Eyebolts
Shipment &
Handling
I. SHIPMENT
Prior to shipment, all Titan-II Motors undergo extensive electrical and mechanical testing, and are thoroughly
inspected. Upon receipt of the motor, carefully inspect the unit for any signs of damage that may have occurred
during shipment. Should such damage be evident, unpack the motor at once in the presence of a claims adjuster
and immediately report all damage and breakage to the transportation company and U.S Electrical Motors.
When contacting U.S Electrical Motors concerning the motor, be sure to include the complete motor identification
number, frame and type which appears on the nameplate (see installation record in this manual).
II. HANDLING
The equipment needed to handle the motor includes a hoist and spreader bar arrangement of sufficient strength
to lift the motor safely. The spreader bar arrangement should always be employed whenever multiple lifting lugs
or eyebolts are provided (See Figures 1A & 1B). The spreader bar should have the lifting hooks positioned to equal
the span of the eyebolts or lifting lugs. The eyebolts or lifting lugs provided are intended to lift the motor weight only.
See Table 6 for motor weights.
CAUTION
Lifting the motor by means other than specifically noted may result in damage to the
motor or injury to personnel. Note that the eyebolt on the top of WPII enclosure is intended
for lifting the tophat only.
1