Estate 9782188A Marine Radio User Manual


 
17
CONTROL PANEL
Do not use abrasive cleaners, steel-wool pads, gritty washcloths
or some paper towels. Damage may occur.
Glass cleaner and soft cloth or sponge:
Apply glass cleaner to soft cloth or sponge, not directly on
panel.
OVEN CAVITY
Do not use oven cleaners.
Food spills should be cleaned when oven cools. At high
temperatures, foods react with porcelain and staining, etching,
pitting or faint white spots can result.
Self-Cleaning cycle:
See Self-Cleaning Cycle first.
OVEN RACKS AND ROASTING RACKS
Self-Cleaning cycle:
See Self-Cleaning Cycle first. Remove racks or they will
discolor and become harder to slide. If this happens, a light
coating of vegetable oil applied to the rack guides will help
them slide.
Steel-wool pad
BROILER PAN AND GRID
Do not clean in the Self-Cleaning cycle (on some models).
Mildly abrasive cleanser:
Scrub with wet scouring pad.
Solution of
¹₂
cup (125 mL) ammonia to 1 gal. (3.75 L) water:
Soak for 20 minutes, then scrub with scouring or steel-wool
pad.
Oven cleaner:
Follow product label instructions.
Porcelain enamel only, not chrome
Dishwasher
Oven Light
The oven light is a standard 40-watt appliance bulb. It will come
on when the oven door is open. It will not work during the Self-
Cleaning cycle. On some models, when the oven door is closed,
press OVEN LIGHT to turn it on or off.
Before replacing, make sure the oven and cooktop are cool and
the control knobs are in the off position.
To replace:
1.
Unplug range or disconnect power.
2.
Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3.
Turn bulb counterclockwise to remove from socket.
4.
Replace bulb and bulb cover by turning clockwise.
5.
Plug in range or reconnect power.
Oven Door
For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven is off
and cool. Then, follow these instructions. The oven door is heavy.
To Remove:
1.
Fully open the oven door.
2.
Tighten clips with a #2 square or Phillips screwdriver.
3.
Close oven door to the stop position (open about 4 in.
[10 cm]).
4.
Lift door slightly and pull out and back until hinges come out
to the catch position.
5.
Push door down and pull straight out to remove door
completely.
To Replace:
1.
Hold oven door by the handle and place the top of the door
under the cooktop overhang.
2.
Use front of leg to apply pressure to slide hinges into the slots
as far as possible.
3.
Use side of leg to apply pressure to the bottom of the door
front.
4.
Lift door slightly. Apply pressure and push until the hinges
have gone in fully.
5.
Fully open the door.
6.
Tighten clips with a #2 square or Phillips screwdriver.
Storage Drawer
The storage drawer can be removed. Before removing, make sure
drawer is cool and empty.
To Remove:
1.
Pull drawer straight out to the first stop.
2.
Lift up the back of the drawer and pull out.
To Replace:
1.
Fit the ends of the drawer rails into the guides in the cavity.
2.
Slide the drawer closed.
4"
4" (10 cm)