Fujitsu G800 Marine Sanitation System User Manual


 
3
NOTES
S.M.A.R.T.function
S.M.A.R.T. function is available in the conbinations shown below:
Internal Hard disk units Hard disk cabinet
IDE SCSI Hard disks GP5UR1DC4/GP5MS622A
Models
Standard
equipment
Standard
equipment
SCSI card RAID card
SCSI card
RAID card
GP5-125 GP5-126 GP5-127 GP5U141GP5U142GP5-143 GP5-144 GP5-146 GP5-125 GP5-126 GP5-127 GP5U141 GP5-144 GP5-146
C300i (GP5C300-375) - --x- -- -x--
C300i (GP5C377-379) -- -x- -- - - x--
C800i - ---x- -- --
-
x--
G800i - ----x-■■ -- x ■■
L800i - - -----■■ -- - ■■
M800i ---- ---■■ -- - ■■
HS900 - - -----■■ -- - ■■
Mounting additional memory
A memory board with 16slots is standard equipment and up to 16GB memory can be mounted. When you use over 16memory slots, an additional
Memory Board (GP5-RB201) is required. When using two memory boards in HS900, the same memory size must be mounted on each board.
Additional PSU in G800i
When a DLT unit (GP5-DL351) is mounted, an additional PSU (total two PSU) is required.
The restriction of the mount of 2 CPUs, 5HDD or 3 PCIs is cancelled.
(HS900)
Memory must be expanded in bank units by mounting four similar capacity DIMMs in one bank. DIMMs must also be mounted in ascending order of
memory capacity alternately on the two RAM base cards.
(M800i)
Mount the same capacity DIMM's in units of four. (Mounting of DIMM's with different capacities or a set of less than four DIMM's is not allowed)
Mount the DIMM's in ascending order of their capacity. Use DIMM slots in the order from bank A (J1 to J4) to bank D (J13 to J16)
(L800i)
The motherboard has four slots for RAM modules (including standard equipment), install RAM modules in slot number order. (teamserver C3xxi
has three slots)
(G800i/C800i/C300i)
:
Corresponds , x:Does not correspond , -:N/A