Furuno 1722C Marine RADAR User Manual


 
1. OPERATIONAL OVERVIEW
1-14
1.6.4 Selecting radar source
When other network radar is connected to the equipment, you may select an
image source as shown below. This is not necessary when no other network
radar is connected. Select one host name for the source though there are two or
three radar units on the net.
Note: Turn the power off whenever changing the source.
1. Press the [DISP] key.
2. Press any soft key to show the following display.
RADAR SOURCE
RADAR
- - -
SOUNDER SOURCE*
SOUNDER
-
IP ADDRESS
172.031.003.001
HOST NAME
RADAR
- - -
SELECT
SOURCE
EDIT
RETURN
IF THERE IS MORE THAN
ONE NETWORK RADAR OR
ECHO SOUNDER, YOU MAY
SELECT THE IMAGE
SOURCES FOR DISPLAY.
*: Do not change this setting.
Select source menu
3. Use the cursor pad to select RADAR SOURCE and press the EDIT key.
RADAR SOURCE
RADAR
- - -
Radar source
Radar source and sounder source windows
4. Use the cursor pad and [ENTER] knob to enter source host name: or to
select position and rotate the [ENTER] knob to select character.
5. Press the [ENTER] soft key or [ENTER] knob.
6. Confirm that the correct host name is entered.
7. Press the [DISP] key to finish.
8. Turn the power off and on again.
Note: Sources names are determined at installation. For example, the source
names for radars in a two radar system might be “RADAR” and
“RADAR1”.