Furuno 1733c Marine RADAR User Manual


 
1-27
Stay
Cable grand
Antenna unit, cover opened
5. Unfasten the cable gland assembly (four screws, plate, gasket).
6. Pass the signal cable with connector through the bottom of the antenna unit.
7. Pass the cable through the gland assembly as shown below.
Plate
Screw
Gasket
Passing the signal cable through the cable gland assembly
8. Position the signal cable so that approximately 1 mm of the sheath is exposed as shown
below. Tighten fixing screws.
Fasten the crimp-on lug on the shield to one of the fixing screws of the cable gland
assembly.
CABLE GLAND
Plate
Gasket
Screw
1 mm
Tubing
Shield
How to fix signal cable in cable gland