Filter
Top Products
5-1
5. IO DATA
Available input and output data are shown in the tables below and input and output sentences are
shown on the next page.
Note: This radar accepts position data fixed by WGS-84 geodetic datum only. Set the datum to
WGS-84 on the EPFS (GPS, etc.) connected to this radar. If other type of datum is input, the error
message "DATUM" appears and the AIS feature is inoperative.
Input
Output
Data Specifications Contents Remarks
Heading
signal
Synchro or step GC-10 required Switching between AD-10
and IEC 61162 is done
from menu.
AD-10 format External AD-100
IEC 61162-2
Speed signal IEC 61162-1
Navigator
data
IEC 61162-1 Position, course, speed, LORAN-
C TD, waypoint, route, time, wind
speed and direction, current data,
depth, water temperature, roll,
pitch, ROT
External
radar signal
Heading, Bearing,
Trigger, Video
No GAIN, STC control Operate as remote display
Alarm ACK
input
Contact closure
signal
Input signal from alarm
system
Track Control
unit
RS-422 Option
Data Specifications Contents Remarks
Radar system
data
RS-232C RSD, OSD, TLL For PC plotter
ARPA data IEC 61162-1 TTM For ECDIS
Remote display
signal
Heading, Bearing, Tx
Trigger, Video
2 ports
External LCD
monitor signal
DVI Same as main monitor unit 2 systems max.
External CRT
monitor signal
R, G, B, H, V Same as main monitor unit Option
Alarm signal Contact closure
signal
Output to alarm system by using
photo-relay
4 outputs, output
content selected from
menu.