Filter
Top Products
88
SIGNAL
STRENGTH
TUNING
MODE
SOURCE NAME
SELECTED
FREQUENCY
ADJUSTING VOLUME LEVEL
To adjust the volume level:
MUTING OUTPUT
To mute and unmute the volume:
Turn Encoder Turn Encoder to
adjust.
The Volume
screen is
displayed
Press Menu to exit.
See “Menu Key
Operation” on page 5.
Figure 1 – Example source screen (AM input selected)
Mute
• PresstheMutekeytomutetheaudiooutput.TheMuteiconisdisplayedoverthe
top of the current input source screen.
• PresstheMutekeyagaintounmutetheaudiooutput.Thevolumecontinuesatthe
previously set level.
25
My Head unit keeps turning itself off then back on when connected to my iPod
This could be happening due to corrupt files and/or a corrupted version of the operating soft-
ware on your iPod. If you connect to your computer you may get a message on the iPod similar
to this: “The iPod ‘John’s iPod’ could not be updated because the firmware was corrupt.
Click this link to get a step-by-step guide to solve this issue: http://support.apple.com/kb/
ts1813.”
Why does my FUSION Head unit keep locking up when connected to my iPod/iPhone?
If you are experiencing software lock-ups or your unit freezes:
• Reset the Head unit by holding down the power button for 10 seconds or pressing the
reset button inside the face plate.
• Reset your Apple iPhone by powering down and then restarting the phone.
• Reset your iPod (see Apple website from model-specific information). This should resume
normal operation.
• Make sure you have the latest version of iTunes and the latest operating software in your
iPod/iPhone. It is important to update software when Apple releases new versions. If you
are connected via a dock, ensure you are using the correct sleeve and the connection to
the Head unit is secure.
Will my iPod/iPhone connect to my FUSION product if the battery is flat?
No. It will take a number of minutes for the Apple product to get a minimum level of charge
before it can connect and become operational. Please connect and wait for the unit to initialise.
My iPod/iPhone will not connect to the Head unit while in the dock.
If your Head unit displays “No iPod connected” while using iPod as input source:
• Check that you are using the correct sleeve combination. If you have the incorrect sleeve
combination this could prevent the iPod connector from mating correctly. It could also
damage the connector in the dock or your iPod/iPhone itself.
If you are uncertain which iPod model you have, go to http://www.apple.com/support/ to get
the correct model information for your iPod and sleeve.
If you are still unable to connect once you know for certain you have the correct iPod/iPhone–
sleeve combination:
• Ensure that you have the latest version of operating software installed in your iPod/iPhone
and the latest iTunes version. To do this, connect your iPod/iPhone to iTunes and it will
check and, if necessary, prompt you to download the latest version.
If you are still unable to connect once you have confirmed that you have the latest software or
you have updated your iPod/iPhone:
• Reset the iPod/iPhone (see the user manual for your Apple product) and also reset the
Head unit (see FUSION user manual).
If you are still unable to connect:
• Contact your FUSION dealer or contact FUSION via the tech email.